Siglent SDS1204X-E

Description

Siglent SDS1204X-E

The SIGLENT Siglent SDS1204X-E is a digital oscilloscope designed to help engineers observe, measure and troubleshoot electrical signals during design, validation, production and service. Oscilloscopes reveal signal behaviour over time, making it easier to investigate timing, noise, transients, overshoot and interactions between circuit nodes.

Product overview

This oscilloscopes solution is intended for engineers and technicians who need practical, repeatable measurements while developing, verifying or maintaining electronic equipment. Review the model-specific ratings and any optional functions to ensure they meet your test requirements.

Series: SDS1000X-E

Key specifications and features

• 200 MHz
• 4 channels
• 1 GSa/s
• 14 M memory depth
• 100, 000 wfm/s waveform capture rate
• 7'' display (800*480 pixels)
• SPO technology, 1 Mpts FFT, Serial bus triggering and decode (Standard), supports IIC, SPI, UART, RS232, CAN, and LIN；Support MSO, USB AWG, Bode Plot；

Applications

Typical applications include embedded-system debugging, power-electronics analysis, serial-bus investigation, signal-integrity checks and general electronic design verification.

Choosing the right configuration

Performance and available functions can differ between variants and optional software or hardware. Confirm the required bandwidth or frequency range, input/output limits, channel count, measurement ranges, accessories and options against the official SIGLENT datasheet before ordering.

Buy SIGLENT test equipment in Australia and New Zealand

C-PRAV Tech supports customers across Australia and New Zealand with SIGLENT test and measurement solutions. Contact our team for a quotation, product selection assistance or advice on building a test setup for your application.